I need a 22M resistor, so I solder two 10M's + one 2M in series.
However, when I measure the end terminals, I end up with something like 32M ?
When I measure in the middle *between* the two 10Ms (the 2M comes last), I get about 20M.
Once again, I am puzzled by this illogical behaviour.
_g
However, when I measure the end terminals, I end up with something like 32M ?
When I measure in the middle *between* the two 10Ms (the 2M comes last), I get about 20M.
Once again, I am puzzled by this illogical behaviour.
_g