If I was to use a CGS24 gate to trigger converter, would I need to
have the 8 gate channels of the sequencer go into 8 separate channels
of gate to trigger conversion that would then go go to the mix gate
out (between the gate out and the switch), or would I just use one
converter at the end of the mix gate out?
Thanks,
Dave
have the 8 gate channels of the sequencer go into 8 separate channels
of gate to trigger conversion that would then go go to the mix gate
out (between the gate out and the switch), or would I just use one
converter at the end of the mix gate out?
Thanks,
Dave
--- In cgs_synth@yahoogroups.com, sasami@... wrote:
>
> > Thanks for the suggestions. I have finally gotten a chance to try
> >out your second suggestion. I put 100n caps between each gate out and
> >the bottom lug of the switch and then a 100k resistor between the mix
> >gate out and ground (I tried without the 100k first). The mix gate
> >out now does not trigger at all and the individual gates still only
> >trigger every second step. Did I miss something?
>
> you are trying to make gate to trigger converters here. Yes, 22k is
too low
> a value. Thinking about it, you syould probably add a diode in
series with
> each cap too.
>
> > I'm not sure how to do the first suggestion [cutting the inhibit in
> >to the gate 4051 (pin 6 )and connecting it to the clock instead (pin 7
> >of the quad op-amp)], if I do try it should I first take out the 100n
> >caps and the 100k resistor?
>
> Yes, I would take them out first. This method would be the better
method of
> doing it.
>
> Ken
> _______________________________________________________________________
> Ken Stone sasami@...
> Modular Synth PCBs for sale <http://www.cgs.synth.net/>
> Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
>