I am about to start building my first CGS-48 VCO (Rev 0.4 board) and I
just want to make sure that I understand the correction instructions
correctly. Specifically the instructions to "Cut the track between Pin
5 of the TL072 in the bottom right corner and the 47uF capacitor."
and "Jumper pin 5 to the Saw AC output terminal via a 100k."
It doesn't look as if this modification is reflected in the schematic
and assuming that it isn't, is this modification the same as connecting
the TL072-pin 5 to the negative side of the 47uF cap with a 100K
resistor instead of just a plain old trace?
Thanks in advance,
James
just want to make sure that I understand the correction instructions
correctly. Specifically the instructions to "Cut the track between Pin
5 of the TL072 in the bottom right corner and the 47uF capacitor."
and "Jumper pin 5 to the Saw AC output terminal via a 100k."
It doesn't look as if this modification is reflected in the schematic
and assuming that it isn't, is this modification the same as connecting
the TL072-pin 5 to the negative side of the 47uF cap with a 100K
resistor instead of just a plain old trace?
Thanks in advance,
James