Yahoo Groups archive

Cgs synth

Index last updated: 2026-04-28 23:16 UTC

Message

Re: Bi-N-Tic, Trim Help

2006-12-01 by sasami@hotkey.net.au

>Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack
1volt, which I have done, now adjust trim until output oscillator is one
volt higher.

1 octave higher, not one volt.

>Where is the oscillator out on the Bi-N-Tic, and is this correct so far.

The pad you want is marked CLKO. Its near pin 8 of IC4


Ken
_______________________________________________________________________
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.