Bc2000 (for the BCF2000 & BCR2000)

Exactly, .default is the starting point for the controller

If you want to output the values of all the controls when you change
to that preset use 
.snapshot on
 in the
$preset
section.

When you change from one BC preset to another the current values are
remembered and are returned to the controls when you reselect that
preset. The .snapshot outputs theses values and that should sync your
synth.

You can send a snapshot at any time by holdig  "EDIT" and pressing 
"<PRESET"


>
> Real easy! Just you use a ".default n" line
> eg.
> 
> .default 64
> 
> -k0mp0
> 
> 
> 
> --- In bc2000@yahoogroups.com, Carma Trepp <carma_trepp@> wrote:
> >
> > Hi all
> > 
> > It is possible to save the the initial values within a Preset?
> > When I power on the BCR the initial values on all Knobs an Buttons
are 
> > all on 0. Can I change this? So when I power up the BCR (or change
the 
> > preset) all Knobs and Buttons shows a different  value on the LCD
Rings.
> > 
> > I would like to do this, to get a starting point for a initial Soft 
> > Synth Preset (my Sequenzer does not Support Parameter Feedback).
> > 
> > Carma
> >
>