Hi Greg
this is the 'big ask' for the BC.
Unless the synth will output all its values in CC (continious controller) messages the BC can understand the data.
Usually the patch data is output as System Exclusive (sysex) and the definition of what is in the sysex message is up to the manufactures of the synth so there is no way Behringer could allow for this for every synth out there.
The only way to do it is write a PC program that sits between the BC and the synth.
I have done this for the Korg DW6000 and the Yamaha 4op synths like the TQ5.
See my web site www.bwalk.com.au to see it in action.
All the best
Royce
---In bc2000@yahoogroups.com, <gregshawdj@hotmail.co.uk> wrote:
Hiya guys
I currently have my BCR-2000 loaded with a template for my ATC-1 analogue synth and have them both connected using midi cables. The BCR is controlling the synth well and I even have my midi keyboard going into the BCR where it merges the signal great stuff :-)
What I was wondering was, is it possible to get the ATC-1 to send its preset settings to the BCR so that all of the encoder lights change when different presets are selected? This would help loads because at the moment all the encoders stay at zero when new patches are selected on the ATC or via the BCR.
Hope you can help
Thanks Greg