Erik, i would've thought that Native Instruments would've have been able to accept the 14bit Control modes. i remember reading about this 14 bit resolution stuff and figured that this should (when used with any of the knobs in Kontakt2 etc) give me what i was looking for. I've tried the Absolute (14 Bit) Control mode with kontakt 2, and the values still jumped! so what do the relative modes do? i dont understand their function --- In bc2000@yahoogroups.com, "Erik Bowen" <erik.bowen@...> wrote: > > I know that the (14 Bit) ones are the same as the regular ones in every > respect except that the 14 bit ones operate at a higher resolution. > However, not all software/equipment accept the 14 bit ones, so you have to > read or experiment to find out which one to use > > > ----- Original Message ----- > From: "kmxe" <kmxeproductions@...> > To: <bc2000@yahoogroups.com> > Sent: Thursday, March 23, 2006 5:11 AM > Subject: [bc2000] 2 q's re: BCR CTRL Mode in BC Edit Program & movings knobs > cause jumps in value > > > > There is a selection between > > > > Absolute > > Relative 1 > > Relative 2 > > Relative 3 > > Absolute 1 (14 Bit) > > Relative 1 (14 Bit) > > Relative 2 (14 Bit) > > Relative 3 (14 Bit) > > > > What do these mean/do? i've tried each of them with the cell volume > > of Battery 2, and besides Absolute, all of the others either moves > > the fader erratically (and not in a linear fashion) or doesnt move > > it at all. > > > > Also, when i move the knobs, the values on whatever i tie them to > > increase/decrease in jumps. What i mean is, if i tie a knob to the > > same volume fader as above, it might be 0db, then moving the knob > > very slightly might jump the volume to 0.3db, is there anyway to set > > it up so it moves the value in proper increments??? > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > -- > > No virus found in this incoming message. > > Checked by AVG Free Edition. > > Version: 7.1.385 / Virus Database: 268.2.6/287 - Release Date: 3/21/2006 > > > > >
Message
Re: 2 q's re: BCR CTRL Mode in BC Edit Program & movings knobs cause jumps in value
2006-03-23 by kmxe
Attachments
- No local attachments were found for this message.