SergeModular

I sent this once but it didn't seem to get through
Hmmm... well i patched this up and i get no bleed
through from the clock signal into the TKB through the
VCM. Are you properly grounded? bad patch cable? I'm
at a loss.Anyone else?? What i did discover though was
a truely righteous patch based on your set up.Dig this
:
VC clock to 11:00 or DTG to equivalent
Clk drives TKB but also a PDIV
stage three of the PDIV into HOLD of TKB
NTO sine to "in" 1 of VCM NTO is set to 10:00
NTO saw to "in" 2 of VCM... or you can flip them
VCM to VCFQX "in" with freq set to 1:00
use row D of TKB just like you did but stack output to
VCF "in" of filter also... set pot to just past 12:00
adjust row D of TKB to taste.
I just got a smokin' boogie shuffle out of this
patch.
I'm laughing my ass off. Thanks man!!!
Kind regards
John DuVal










--- In SergeModular@yahoogroups.com, jan-hinnerk.helms@t...
wrote:

> Dear SMOG,
>
> I finally made the step and now have my own Animal and a

[TKB]. But on

> running some first tests, I encountered the following

phenomenon and

> would like to ask you to confirm if this is normal or not.
>
> In short: If I use a row of my [TKB] to control one section of my
> [VCM], the clock pulses triggering the [TKB] and KP can be

"heard" in

> the audio running thru the [VCM].
>
> To verify if this is the case on your system, here comes the very
> simple patch:
>
> - Patch [DTG] to cycle
> - [DTG] Gate out to [TKB] clock in
> - [TKB] KP to hold input of [TKB]
> - [TKB] row D to VC in of [VCM] middle section
> - [NTO] or [PCO] sine to [VCM] middle section In2
> - [VCM] middle section out to [UAP], from there to monitor
>
> - Set [NTO] or [PCO] to audio range, bass register works best
> - Set [DTG] rise and fall controls so that [DTG] oscillates at 2 to

10

> Hz
> - Set [VCM] middle section VC pot to zero
> - Press and hold any step on your [TKB]
> - While holding the step, turn this steps's row D pot quite

slowly from

> zero upwards
>
> Result on my system:
>
> In between the positions 8 AM o'clock to 2 PM o'clock of the

row D

> pot, the clock signal triggering the [TKB] can be clearly heard
> bleeding into the signal going thru the [VCM]. Below these

positions,

> the [VCM]'s effect is so weak or so strong, that this bleeding

can not

> be heard.
>
> Please, set up this patch and test on you system, so that I can

find

> peace again (whether by knowing these is something wrong,

or by

> knowning that this is normal).
>
> Thanks so much in advance,
> Jan-Hinnerk