What does an SSG output when it's set to oscillate? I seem to remember it
being around 5V P-P (-2.5 to =2.5). Is that accurate?
Romeo
on 7/9/02 8:39 PM, John Loffink at jloffink@... wrote:
being around 5V P-P (-2.5 to =2.5). Is that accurate?
Romeo
on 7/9/02 8:39 PM, John Loffink at jloffink@... wrote:
> Serge audio and control voltage outs are 5 volts peak to peak. Black
> jacks are centered around 0 volts (-2.5V to +2.5V), blue jacks run 0 to
> 5 volts.
>
> Gates and Triggers appear to be around 11 volts output. I haven't
> tested these to see what input voltage is required to trigger them.
>
> As I recall output impedance was 330 ohms typical and input impedance
> was maybe 50K ohms.
>
> These values are generally compatible with other modulars. Sometimes
> you may need to scale or shift the values. For instance, Wiard tends to
> use 0 to 10 volt ranges. MOTM and Synthesizers.com use 0 to 5 volts for
> gates and envelopes and -5 volts to +5 volts peak to peak for just about
> everything else.
>
> John Loffink
> jloffink@...
>
>> -----Original Message-----
>> From: peff2cv [mailto:m_2_f@...]
>> Sent: Tuesday, July 09, 2002 6:31 PM
>> To: SergeModular@yahoogroups.com
>> Subject: [SergeModular] Serge interface standards?
>>
>> Quickie question: what are the interface standards for Serge (besides
>> the obvious 1V/oct CVs)? Trigger/gate levels? Input and output
>> impedances? Any known "conflicts" with other modular gear?
>>
>> thanks
>>
>> Peff
>>
>
>
>
>
> To unsubscribe from this group, send an email to:
> SergeModular-unsubscribe@yahoogroups.com
>
> Keep on Patchin'!
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>