QTR-Quadtone RIP

Hi Tom!

Ahhhh, sometimes the solution is so near...

I didn´t read quite wll the title of the thread. And of course if
somthings comes out like '#+´??888' it must be something with the
printer driver...

Next time I will read the content with a little bit more attention!

CU

Peter


--- In QuadtoneRIP@yahoogroups.com, "Tom Moore" <rtmlists8888@...> wrote:
>
> Jorge
> 
> It sounds like you are not using the correct Printer Model. My
version of
> QTRgui does not have a model for the R2880. If Peter had not said
that the
> printer is working for him (presumably with QTR) I would have
guessed that
> QTR doesn't support this model yet.
> 
> Since Peter says that it is working for him, make sure you are using the
> same printer model he is. The Printer Model tells QTR what low level
command
> set to use for the printer.
> 
> Tom Moore
> 
> > -----Original Message-----
> > From: QuadtoneRIP@yahoogroups.com
[mailto:QuadtoneRIP@yahoogroups.com] On
> > Behalf Of rabanito
> 
> ...
> 
> > thank you for the hints. I got something else, perhaps this could help
> > to understand what's happening.
> > 
> > First I uninstalled and installed again. I even tried a former version
> > but the result is the same.
> > 
> > NOW:
> > 
> > - I used 21step.tif as you proposed.
> > - I fed enough sheets (A4)just to see what happens.
> > - The first sheet got printed a horizontal line (or wedge)about 1mm
> > thickness
> > - the next 3 or 4 sheets got nothing
> > - The 5th sheet got gibberish like ..@A@L@@DA@D@AADD@@DD@@@....etc
> > 
> > Looks like QTR and my printer are not speaking the same language, but
> > I am a novice in these matters... I presume there is something to be
> > done that I missed...
> > 
> > Thanks again
> > 
> > Jorge
>