QTR-Quadtone RIP

--- In QuadtoneRIP@yahoogroups.com, "Michael King" <drmrking@...> wrote:
> I found it hard to judge where the start and end were without the 
> marks. I think you have to be at least a square width before and 
> after.

I wonder if my problem was printing the target in portrait mode on A4.
 It fits, but there isn't much blank paper either side

> > > Yes use spot measurement and select densitometric.
> >
> > I don't seem to have that option. Is that because it is not longer
> > enabled in the demo (5.0.8), or because I only installed the
> > MeasureTool, and should have also installed some other components 
> > of PM5?
> 
> It's greyed out in the demo mode.

I don't see it at all in "measuring chart" or "measuring spot".  It is
there but greyed out in "calculating".  But whatever, it does seem to
be a demo limitation.

Thanks.

Ferdinand