QTR-Quadtone RIP

As a general rule of thumb, if the output gets spooled, it is a problem for Roy.

FYI, I have just tried printing a calibration target on my 2200. It also spools
to the printer, the printer cogitates a bit, then spits out a blank page.  No
errors or anything else unusual in the logs, so, something has gone wrong. 


-Stephen
 www.sbillard.org/Stephen

-----Original Message-----
From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On Behalf
Of dmdctusa
Sent: Thursday, February 15, 2007 1:19 PM
To: QuadtoneRIP@yahoogroups.com
Subject: [QuadtoneRIP] Problem printing color calibration test - Epson 2200 /
QTRgui 2.5.0.5

Not sure if this is for Roy or Steven

Today I decieded start my first profile.  Following Tom Moore's guidance, I
started to print the ink chracterization calibration test sheet.

After I select the calibration option, the tiff image appears in the image box.
When I click print the job seems to spool to the printer and the printer starts
but the sheet never prints.  Afte a few seconds the job disappears from the
print status screen and the paper ejects.

The printer is printng normally as a 2200 from Lightroom PWPro and other apps.

Any ideas as to the problem.  Should I print directly to the printer and avoid
the spooler.

I use the QTRgui clean before I installed ver. 2.5.05. 

Any and all help is appreciated.

David Dorn
Connecticut