QTR-Quadtone RIP

I'm out of town for the weekend, so can't look into this until next week
sometime. In the mean time, try dragging and dropping the image you want to
print onto the GUI. 



- Stephen 
-----Original Message-----
From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On
Behalf Of Eric Neilsen
Sent: Saturday, October 28, 2006 1:23 PM
To: QuadtoneRIP@yahoogroups.com
Subject: RE: [QuadtoneRIP] Problems after Upgrade

The error message occurs when I try and open a new image; one not on the
currently used list. I have uninstalled it, twice and run the clean up
after. I re installed it and I still get the error message , error setting
path; e: ...

 

There may be normal functioning afterwards but it will only call up the test
images and while they can be useful, they are not so wonderful to look at :
) 

 

If the folder monitoring is indicated by the not monitoring in the lower
left, it is set to not. What can I get rid of that will clear the path to
allow for new images?  

 

 

 

Eric Neilsen Photography

4101 Commerce Street

Suite 9

Dallas, TX 75226

http://e.neilsen.home.att.net

http://ericneilsenphotography.com

Skype ejprinter

  _____  

From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On
Behalf Of Stephen Billard
Sent: Saturday, October 28, 2006 1:10 PM
To: QuadtoneRIP@yahoogroups.com
Subject: RE: [QuadtoneRIP] Problems after Upgrade

 

When (what are the circumstances) does the error occur? Do you have folder
monitoring on? Are there any parameters on the command line for the QTRgui
shortcut? Does everything function normally after the error message? 

- Stephen
-----Original Message-----
From: QuadtoneRIP@ <mailto:QuadtoneRIP%40yahoogroups.com> yahoogroups.com
[mailto:QuadtoneRIP@ <mailto:QuadtoneRIP%40yahoogroups.com> yahoogroups.com]
On Behalf Of Eric Neilsen
Sent: Saturday, October 28, 2006 7:52 AM
To: QuadtoneRIP@ <mailto:QuadtoneRIP%40yahoogroups.com> yahoogroups.com
Subject: [QuadtoneRIP] Problems after Upgrade

Last night I upgraded to 2.4.3 and qui 2.4.3.12. When I try and open a new
document, I get an error message that a path to a previously used file
cannot be located. I am not using the saved list, but just trying to open a
new image. I ran clean out before installing both up dates. What to do?

Eric

Eric Neilsen Photography

4101 Commerce Street

Suite 9

Dallas, TX 75226

http://e.neilsen. <http://e.neilsen.home.att.net> home.att.net

http://ericneilsenp <http://ericneilsenphotography.com> hotography.com

Skype ejprinter

[Non-text portions of this message have been removed]

Yahoo! Groups Links

 



[Non-text portions of this message have been removed]



 
Yahoo! Groups Links