PLAN B analog blog

I'll leave that to the experts...Ikea.

OK Gents, it's past 3 AM here, time for some Zzzzzzzzz's.


--- In PLAN_B_analog_blog@yahoogroups.com, amnesia <amni56@...> wrote:
>
> why not have these cases for sale as precut kits?
> Plan B wood!
> 
> 
> (i think you can figure that out) wrote:
> >
> > It's made from 3/4 inch MDF - this is the high-density compressed
wood 
> > used
> > for a lot of speaker cabinets. It'll run you $35 or so an 4 x 8 sheet.
> >
> > I did a rendering of the shape of the side plate in
> > Freehand/Illustrator in scale. I had the lumber yard cut out the
> > sides as a rectangle, then print out the arch (which in this instance
> > fit on a tablet 17 x 11 piece of paper) and glued it to the corner of
> > the one of the wood sides with rubber cement. Used a hand-held
> > electric jig saw to cut away the arch using the printed line as a
> > guide, then used that cut-out side for the trace template for the
> > other end plate. One both are cut I clamped the two ends together and
> > sanded the face of the arch on both together until they were smooth
> > and uniform.
> >
> > Using two sets of right-angle bracket clamps and wood cement I glued
> > the cabinet together, then routed the edges with a bull-nose bit and
> > sent it to the paint shop. It tok me about two hours form start to
> > finish to make the cabinet.
> >
> > Once back from painting, I bolted in the Vector rails to mount the
> > modules to then cut the back plate to size, mounted that to the back
> > using two pieces of 3.7 inch aluminum angle iron, cut out/filed the
> > clearance patterns for the fuse, IEC connector and power switch anf
> > the two 1/4 jacks for the rear outputs, mounted the PSU's inside and
> > used two Model 1's as the dist. strips and bang - it was completed.
> >
> > I used Molex connectors for all the primary cabling so that the rear
> > panel can be completely removed for rear access if required.
> >
> > If you have the tools, the complete chassis will cost you about $250
> > all things considered (painting was a bit more than I wished, but the
> > shop which was going to do it wanted surprised me at the very end with
> > a two week turnaround when they usually do it overnight,...and I had
> > exactly three days in which to do it! I had to hunt around for a
> > facility who could spray wood (nobody likes to do this. it's pain in
> > the butt as it requires a lot of paint).
> >
> > hope this helps
> >
> > - P
> >
> > --- In PLAN_B_analog_blog@yahoogroups.com 
> > <mailto:PLAN_B_analog_blog%40yahoogroups.com>, "(i think you can
figure
> > that out)" <peter@> wrote:
> > >
> > > I did!
> > >
> > >
> > >
> > > --- In PLAN_B_analog_blog@yahoogroups.com 
> > <mailto:PLAN_B_analog_blog%40yahoogroups.com>, "drexciyaecho"
> > > <drexciyaecho@> wrote:
> > > >
> > > > Nice system and agree that the case is great. That's the type
cabinet
> > > > I'm looking for , except with the addition of another row on
the top.
> > > > Any info for us on who made the case Peter?
> > > >
> > >
> >
> >
>