Homebrew PCBs

I picked up a pair of Kepro bases - one set up as a 12" shear with an extra 90 degree blade and the other set up as a bender.  I did all sorts of Google searches and only found a couple of message threads, one being here back a few years (2003?).

Anyhow, since these were designed to cut PC boards, I was hoping someone might have some sort of owner/operator manual or know of a place that might have one for sale.

Thanks - John in Northern California

> I picked up a pair of Kepro bases - one set up as a 12" shear with an extra 90 degree blade and the other set up as a bender.  I did all sorts of Google searches and only found a couple of message threads, one being here back a few years (2003?).
> 
> Anyhow, since these were designed to cut PC boards, I was hoping someone might have some sort of owner/operator manual or know of a place that might have one for sale.
> 


Kepro is now D & L Products  www.dalpro.net  but don't think they sell the shear anymore and did not see any information about the shear that Kepro sold.  I have one that I got used, but I don't have any information on it.  

Ben

> 
> Kepro is now D & L Products  www.dalpro.net  but don't think they sell the shear anymore and did not see any information about the shear that Kepro sold.  I have one that I got used, but I don't have any information on it.  
> 
> Ben
>

Thanks Ben.  I sent them an email asking for a manual or two on the old Kepro products.

John