Homebrew PCBs

Ok, I tried the 7.10 Ubuntu and got it to install probably because of a 
different monitor or I just got lucky. Anyhow, I was able to run the 
setup on gEDA but have a few questions now. What programs will be listed 
if I have done the complete install of the gEDA suite in my Education 
folder under Applications? I have managed to find with the package 
manager and install:
Gnu EDA Schematic Editor
PCB Designer

Whats else is supposed to be there if I do it correct?
Thanks,
Dave

Dave <theschemer@...> writes:
> Gnu EDA Schematic Editor
> PCB Designer

That's all you really need to start getting a feel for the tools,
although adding gattrib would be useful.

If you open up a terminal, you can just run "gattrib" at the command
prompt.

You'll need to run gsch2pcb at some point also.

Note: the geda-user mailing list is a good place to ask these
questions.  See http://www.geda.seul.org/

DJ Delorie wrote:
> Dave <theschemer@...> writes:
>   
>> Gnu EDA Schematic Editor
>> PCB Designer
>>     
>
> That's all you really need to start getting a feel for the tools,
> although adding gattrib would be useful.
>
> If you open up a terminal, you can just run "gattrib" at the command
> prompt.
>
> You'll need to run gsch2pcb at some point also.
>
> Note: the geda-user mailing list is a good place to ask these
> questions.  See http://www.geda.seul.org/
>
>
>   
Ok, thanks for the info. Ubuntu 7.10 is much better than 6.06 so I am 
not having any problems that I can't google for now. Just had to get it 
properly installed first, thats all :)
Dave