Synth-DIY Yahoo! Groups Archives

Thread

Pad Cutters Source

2005-09-28 by Radra

Does anyone have any suggestions where I can obtain a set of pad
cutters. Would like to be able to cut various size pads on my PCBs.
One common use will be to isolate pads on the back side of the PCB
for the occasional thru-hole lead components I use.

Lyman

Re: [Homebrew_PCBs] Pad Cutters Source

2005-09-28 by Stefan Trethan

On Wed, 28 Sep 2005 19:32:08 +0200, Radra <infositeus@...> wrote:

> Does anyone have any suggestions where I can obtain a set of pad
> cutters. Would like to be able to cut various size pads on my PCBs.
> One common use will be to isolate pads on the back side of the PCB
> for the occasional thru-hole lead components I use.
> Lyman

dunno where they are sold, you can grind one.
Take a broken drill, grind the end flat to maybe 2mm or so, and grind out
a center pin and cutting points on the sides, like a old fashioned wood
drill without the cutting face on the front. Round that off so you don't
drill the pad away if you don't set the stop correctly.

I've also seen people use small tubes, and file teeth on them.

ST

Re: [Homebrew_PCBs] Pad Cutters Source

2005-09-28 by Leon Heller

----- Original Message -----
From: "Radra" <infositeus@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Wednesday, September 28, 2005 6:32 PM
Subject: [Homebrew_PCBs] Pad Cutters Source

> Does anyone have any suggestions where I can obtain a set of pad
> cutters. Would like to be able to cut various size pads on my PCBs.
> One common use will be to isolate pads on the back side of the PCB
> for the occasional thru-hole lead components I use.

Farnell stocks them. Only one size, though.

Leon
--
Leon Heller, G1HSM
leon.heller@...
http://www.geocities.com/leon_heller
---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]