Homebrew PCBs

----- Original Message ----- 
From: "lcdpublishing" <lcdpublishing@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Monday, June 27, 2005 5:36 PM
Subject: [Homebrew_PCBs] Re: air pumps


> Forgive me, I am sure this has already been discussed but...
>
> I don't know if air is required or not so keep that in mind.
>
>>From the little I have read so far, you need agitation, not actually
> air.  Air is just a way of moving the liquid around for the
> agitation. It also seems that most of the rigs for this are vertical
> to accomodate the rising air.
>
> Would this work...
>
> A shallow, flat tank, sitting horizontal.  Across the center is a
> pivot point and at one end a very small, slow spinning gear motor
> with a cam on it. The cam rubs against the bottom causing the tank
> to rock back and forth.  This would cause the liguid to move back
> and forth in a wave motion.
>
> Adding a couple of standoffs to the circuit board before putting it
> in the solution could be used to keep the board off the bottom of
> the tank.
>
> If nothing else, it might be relaxing to watch it rock back and
> forth :-)

I do the same thing, manually. There was design for something like your 
suggested tank in the ARRL Handbook a few years ago. The etchant was kept 
hot with a heat lamp over the tank.

Leon 

---
[This E-mail has been scanned for viruses but it is your responsibility 
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]