Homebrew PCBs

On Fri, 10 Jun 2005 20:31:05 +0200, <JanRwl@...> wrote:

> Stefan:  This line reminded me, if you make some arbors  and a "table" to
> receive the ends of the bits, a good drill-press will work to  set the  
> plastic
> collars on carbide PCB bits!


I had this thought too, but i do not own a good drill press ;-(
I know i ought to get one, but i can do many things with my drill stand  
and a very good power drill in it, and i refuse to buy a cheap press as i  
fear the motor would be inferior and i would be disappointed. the drill  
stand is lever operated, it is no good to precisely press small increments.

ST