Homebrew PCBs

--- In Homebrew_PCBs@yahoogroups.com, "rruss45826" <rruss45826@a...>
wrote:
> 
> 
> Has anyone here used this type of method? How succesful were you? What 
> kind of equipment did you use? Home made???
> Thanks! 
> Ray Russell

If your looking for more info on a cnc router, try www.cnczone.com, i
haven't been able to mill a pcb after i killed my driver board but
more then a few of the guys at cnczone make good boards with there
routers. Definitly faster then using toner transfer, no chems. There's
a really nice section on open source driver boards aswell. There are
free open source plans for basically everything you need to get
started milling pcb's. I even built my power supply from an old
microwave oven one. Since my machine is down i am working with the
toner transfer method to get some driver boards built so i can get my
router running again.