Homebrew PCBs

javaguy11111 wrote:

> My results were not as good as Stefan's. First the coating did not
> come out as smooth as I would like to have seen it.

Likely due to the texture of the paper acting to self-level
the silicone film.  The paper is also much more compressible
than the transparency film which compensates for irregularities
in both the knife and surface upon which the film/paper rests.

I have heard of success using printer label backer sheet for
this same purpose.  Is there some reason this is not a
viable solution?  It would seem quite cost effective.


-- 
uhmgawa@...        www.gnu.org