On Thu, Nov 04, 2004 at 04:01:59AM +0100, Manuel Bessler wrote:
http://cockpit.varxec.net/tmp/s_img_2704.jpg
The board after removing the paper under running water.
You can see two areas where the toner didn't stick well, and the borders
are not well either, but it didn't pose a problem since it was out of
the way of the "active region".
This is just a mounting board and was made in just a few minutes.
I will try a more complex board within the next two weeks hopefully, and
can then report back on the success or failure.
http://cockpit.varxec.net/tmp/s_img_2706.jpg
a little closer view of the prev. pic.
http://cockpit.varxec.net/tmp/s_img_2715.jpg
... and after etching
Manuel
>OK, here are a few more shots:
> OK, I've uploaded two pictures to my website showing the results of
> Nevr-Dull as a PCB cleaning aid:
>
> http://cockpit.varxec.net/tmp/img2688.jpg
> http://cockpit.varxec.net/tmp/img2691.jpg
>
http://cockpit.varxec.net/tmp/s_img_2704.jpg
The board after removing the paper under running water.
You can see two areas where the toner didn't stick well, and the borders
are not well either, but it didn't pose a problem since it was out of
the way of the "active region".
This is just a mounting board and was made in just a few minutes.
I will try a more complex board within the next two weeks hopefully, and
can then report back on the success or failure.
http://cockpit.varxec.net/tmp/s_img_2706.jpg
a little closer view of the prev. pic.
http://cockpit.varxec.net/tmp/s_img_2715.jpg
... and after etching
Manuel