Well, I was looking for some kapton type materials, but this is thin
enough it might just do the trick if I wire a cable to in instead of
coming off with a printed harness like I was thinking. Its for a
printed sensor/electonics that need to be rolled into a cylinder.
I'll do pictures if it pans out.
---"grantfair2001" wrote:
enough it might just do the trick if I wire a cable to in instead of
coming off with a printed harness like I was thinking. Its for a
printed sensor/electonics that need to be rolled into a cylinder.
I'll do pictures if it pans out.
---"grantfair2001" wrote:
> Glad it got there Dal. I thought that 12 thou thick double-sided I
> sent was thin, but apparently there is stuff as thin as 5 thou
> available, according to Frank at Pulsar.
>
> Can you say what you hope to make with it? Good luck with it.