Homebrew PCBs

On Wed, 11 Aug 2004 15:06:45 -0500, Thomas P. Gootee <tomg@...>  
wrote:

> ---------------
>
> Hello, group.
>
> It's probably already been discussed, here, before (I'm relatively new  
> to this group. So I apologize if this has already been mentioned.), but:
>
> I have seen "plastic storage containers" that look like they would make  
> good etching tanks, for those on a budget.  They are relatively low cost.
>

they were all too thick for me. my tank is 2cm.
not only do you need less etchant for the same size but you also have  
better visibility.

Good idea though (but not new, there are even kits sold with these  
containers).

thanks

ST