Has anyone worked out a tilting table that could be used to tilt the PC boards,
and then to use the corner of a flat end mill? You would have to cut the traces
horizontal, then the vertical ones, but even with a reposition, you might get a
lot of benefit from the edge of a 1/8 or 1/4 cutter vs the center of a V tipped
cutter.
You might get the same effect from angling the spindle, and the table
construction would not get so complicated.
Fred Smith
IMService
and then to use the corner of a flat end mill? You would have to cut the traces
horizontal, then the vertical ones, but even with a reposition, you might get a
lot of benefit from the edge of a 1/8 or 1/4 cutter vs the center of a V tipped
cutter.
You might get the same effect from angling the spindle, and the table
construction would not get so complicated.
Fred Smith
IMService