Homebrew PCBs

Dave,

As far as a four layer board is concerned, an extensive check on 
what's available in the archives and emails with Makrus brought me to 
conclusion that a four layer board is not neccesary to my happieness -
 I don't need it. For thruholes I took the advise to check thinktink 
website and came up with this link:

http://www.thinktink.com/stack/volumes/voli/store/inksup.htm  Zero 
ohm resistors sound very sweet at this point.

Then I found out that he might have a conductive ink

http://www.thinktink.com/stack/volumes/voli/store/specs/inkspec.htm

I think that once we have Ballendo's machine it would be possible to 
use that ink to print our own PCBs.

Mike

"Keep the main thing, the main thing"

--- In Homebrew_PCBs@yahoogroups.com, "Dave Mucha" <dave_mucha@y...> 
wrote:
> <snip>
> 
> > There are posts in the past of me about the topic where I 
describe 
> the
> > process mostly step by step. Please bear with me if I'm too lazy 
to
> > retype all this. I'm also a bit under pressure since I leave to a 
> two
> > week holiday in a couple of hours.
> > 
> > Markus
> 
> I can search the list in a few minutes and offer post numbers so we 
> can all read up while you are on holiday.
> 
> Have a wonderful time on Holiday !
> 
> Dave