Homebrew PCBs

Please educate me, 

What is the Owner address?

Thanks,

Ken


--- In Homebrew_PCBs@yahoogroups.com, Steve Greenfield 
<alienrelics@y...> wrote:
> You send this to the Owner address, not the list address.
> 
> Several alternatives mentioned:
> 
> Label paper with all labels removed.
> 
> Thin glossy magazine pages.
> 
> Print on the back of the heat transfer foil film. The stuff that is
> meant to be heat pressed onto laser toner print. You will need to
> temporarily fasten it to a sheet of paper to make it stiff enough
> to feed.
> 
> Steve, listowner Homebrew_PCBs
> 
> --- SmartDim@a... wrote:
> > Hello Group,
> >  
> > Some time ago I read about an alternative to the "blue" paper you
> > put into  a 
> > laser jet, then iron on to the copper board. If I am not
> > mistaken, I believe  
> > label paper with all the labels removed was used?
> >  
> > Could somebody point me to a link that describes this
> > alternative?
> >  
> > Thank you,
> >  
> > Ken
> > 
> 
> 
> =====
> Steve Greenfield               // Digital photography, scanning,
> Polymorph Digital Photography // retouching, and photomorphing
> 253-318-2473 voice           // to your specs.
> polymorph@p...     // 
> http://www.polyphoto.com/  // Based in Tacoma, WA, USA