Homebrew PCBs

You send this to the Owner address, not the list address.

Several alternatives mentioned:

Label paper with all labels removed.

Thin glossy magazine pages.

Print on the back of the heat transfer foil film. The stuff that is
meant to be heat pressed onto laser toner print. You will need to
temporarily fasten it to a sheet of paper to make it stiff enough
to feed.

Steve, listowner Homebrew_PCBs

--- SmartDim@... wrote:
> Hello Group,
>  
> Some time ago I read about an alternative to the "blue" paper you
> put into  a 
> laser jet, then iron on to the copper board. If I am not
> mistaken, I believe  
> label paper with all the labels removed was used?
>  
> Could somebody point me to a link that describes this
> alternative?
>  
> Thank you,
>  
> Ken
> 


=====
Steve Greenfield               // Digital photography, scanning,
Polymorph Digital Photography // retouching, and photomorphing
253-318-2473 voice           // to your specs.
polymorph@...     // 
http://www.polyphoto.com/  // Based in Tacoma, WA, USA