--- In Homebrew_PCBs@yahoogroups.com, Anthony Toft <toftat@c...>
wrote:
over the board.
The pins will slide easily in the black plastic holder.
Also the black plastic holders are usually knotched for snapping
apart.
I find that it is easy enough to remove a pin at a time when pulling
an old board apart. but really hard to pull apart a 20 pin row at
one time without a torch.
Dave
wrote:
> I am upgrading my Tait Programmer for ICSP and am deciding on theis
> connector, I have pretty much chosen a 2x6 on .1 centers (standard
> looking dual row) but I can't find them that short. How much hassle
> it to cut them off a longer strip (like getting 6 from a 36 pingWhen you said SHORT, I thought you meant lenght of the pins as height
> connector)?
> --
> Anthony Toft <toftat@c...>
over the board.
The pins will slide easily in the black plastic holder.
Also the black plastic holders are usually knotched for snapping
apart.
I find that it is easy enough to remove a pin at a time when pulling
an old board apart. but really hard to pull apart a 20 pin row at
one time without a torch.
Dave