Homebrew PCBs

Ballendo,
  I have done this on an HP 7150.  I have not tried with my epson color 800.
Someone mentioned using a scanner chassis to act as the X axis, instead  
of sheet
feeding.  You could put an aim point or jig on the bottom to hold the 
part e.g.: flush
left for top, flush right for bottom.  I know that most error I've seen 
has been from
page feed, not print head repeatability.  On the HP, I did get pretty 
good alignment,
but I have not looked at it lately.  I'll try and print a 2 sided board 
out tonight.
Richard

>From: "ballendo" <ballendo@...>
>Subject: Re:laser jet consistency and registration
><snip>
>So I'm wondering, Has anyone taken the time to see if he or she can 
>get a good back to back registration on PAPER?
>
>Because if you can't get the sheet of paper to reliably go through 
>twice accurately; isn't it kinda unlikely that the mods to allow a 
>board to go through are gonna improve things?
>
>Next, IF it is possible and likely for the registration of two passes 
>to line up with respect to the board edges: Has anyone held this up 
>to a light and checked if all the holes line up all across the board?
>  
>