Sorry for being a latecomer - the ground may have been covered
before, but I ran out of patience looking thru yahoo's slow engine
on my 26k (on a good day) dialup...
Has anyone used this? I have used it for putting new "stuff" on
silvered clock dials (after replating etc.), and made one small PCB -
if I have the iron set between cotton and linen, it's not bad. Larger
patterns are still a problem with distortion. THeir "green" TRF
does seemto make the toner on copper a lot more robust.
?? / mark
before, but I ran out of patience looking thru yahoo's slow engine
on my 26k (on a good day) dialup...
Has anyone used this? I have used it for putting new "stuff" on
silvered clock dials (after replating etc.), and made one small PCB -
if I have the iron set between cotton and linen, it's not bad. Larger
patterns are still a problem with distortion. THeir "green" TRF
does seemto make the toner on copper a lot more robust.
?? / mark