Hello,
My laminator is a GBC 95p with a thermal cut-off of 152 degrees
celcius. So thats like 305 degrees F. I wonder if you could bypass
the fuse and perhaps lower the resistance in the power resistors?
I made new gears by making a silicon rubber mold of the best original
gear. Then i just poured some liquid plastic, found from tap plastic,
into the mold and out came a gear.
As for your fuser, perhaps you could but a motor on one of the
rollers? You could make a gear/connector piece to make this possible.
My laminator is a GBC 95p with a thermal cut-off of 152 degrees
celcius. So thats like 305 degrees F. I wonder if you could bypass
the fuse and perhaps lower the resistance in the power resistors?
I made new gears by making a silicon rubber mold of the best original
gear. Then i just poured some liquid plastic, found from tap plastic,
into the mold and out came a gear.
As for your fuser, perhaps you could but a motor on one of the
rollers? You could make a gear/connector piece to make this possible.