I will give the Proxxon drill a thumbs up also.
It does get warm if you run it for 20 minutes at a time though.
Don't over-tighten the little drive belt, it's not necessary.
I have a little light shining on the drill point area and also I found an air pump at the junk store to blow the dust away.
I've drilled several thousand hole with mine. !!
On Wed, Nov 30, 2016 at 10:14 PM, Camillus Blockx camillus_blockx@... [Homebrew_PCBs] <Homebrew_PCBs@yahoogroups.com> wrote:
Hi,A good affordable hobby drill is from PROXON. Sears carry's these but only on ordering.
cbOn 11/30/2016 5:28:39 PM, arvidj@... [Homebrew_PCBs] <homebrew_pcbs@yahoogroups.com > wrote:
I bought the Jameco PCB Drill and was quite disappointed. I found it to not be any better than the Dremel Workstation in rigidity and accuracy.