Homebrew_PCBs

> Any suggestions on cutting circuit boards. I have used a bandsaw,

but

> it tends to be slow, dusty and inaccurate. I have tried paper

shears,

> but the board tends to get warped and is only good for about two
> inches and it is too hard to cut any further.
>
> I have seen a few references to using a diamond tile saw. They

have

> wet tile saws with a diamond blade at home depot for $88 but it

seems

> that the blade would get gummed up with epoxy and not cut.

I use a Craftsman Table saw with Diamond blade, and vacumn attached,
also put a cloth shop vac filter over the air intake of the motor to
keep it from getting the dust into the motor. Best method that I
have found.

Bench type Sheet metal shears will work also, paper cutters do not
work very well for this.

Ben

Ben