Homebrew PCBs

Look for a “brayer.”  It is used for inking, for rolling out laminate to be glued down to counter tops and much more.  The rubber can be of varying hardness, depending on application.  Sounds like a hard rubber would work best.

 

From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com] 
Sent: Saturday, January 30, 2016 11:25 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Double sided cold toner transfer experiment

 

  

Hi Roland

A good idea with the cold laminator, I never thought of it. Thank you.

By the way the roller you are using is a roller to apply ink on linoleum carvings. Probably available in a craft store at your end.

Rgds

Jean-Claude



Am 31.01.2016 um 02:18 schrieb rolohar@... [Homebrew_PCBs]:

  

Malcom Parker:

 

Good Idea:

 

I use a rubber roller.......looks something like a paint roller, only smaller and with a rubber roller instead of

fuzzy felt. 

 

If I had a laminator, I would use it with no heat, just to apply even pressure across the surface.

 

One pass should be sufficient.

 

Regards, 

 

Roland F. Harriston, P.D.

***************************