Yahoo Groups archive

Homebrew PCBs

Index last updated: 2026-04-28 23:05 UTC

Message

Plastic Resist From 3D Printer?

2016-01-25 by palciatore@...

I don't know if it has been discussed before, but has anyone ever used a 3D printer to deposit a layer of plastic on a circuit board to use as the pattern for etching? It seems to me that this may be an easy way to do this as no extra steps would be needed, just print and etch.

If so, how did it work? And how did they remove the plastic after the etch?



Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.