Mark,
I have resolved one issue... Cleaning with Acetone didn't do good enough of a job. After re-cleaning the carrier with mild detergent and scotchbrite, Drying with fresh clean cotton dish towel, I am not getting the paper jam indication upon the first pull, and am not getting residual toner on the sheet. Poor conductivity at first, I think. However now, when I print from the PC, the carrier pulls in to about.75 past the trigger hole, and stops with a jam. Is this likely due to the high resistance of the pullup resistor (30.1k) preventing the trigger from working?
Thanks,
Roger
I have resolved one issue... Cleaning with Acetone didn't do good enough of a job. After re-cleaning the carrier with mild detergent and scotchbrite, Drying with fresh clean cotton dish towel, I am not getting the paper jam indication upon the first pull, and am not getting residual toner on the sheet. Poor conductivity at first, I think. However now, when I print from the PC, the carrier pulls in to about.75 past the trigger hole, and stops with a jam. Is this likely due to the high resistance of the pullup resistor (30.1k) preventing the trigger from working?
Thanks,
Roger
On 4/5/2015 5:31 PM, Mark
mlerman@... [Homebrew_PCBs] wrote:
Roger,
This usually happens if the NPIS doesn't see the hole in the carrier. Did you remember to drill one?
Mark
-----Original Message-----
From: "Roger Blair Roger.Blair@... [Homebrew_PCBs]"
Sent: Apr 5, 2015 10:33 AM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Re: DLP MCU version troubleshooting, help needed
Hi Mark (& Marc), again...
I found a few overlooked corresponding emails from earlier in time, and with a little more information... I have just completed wiring the printer as follows, and have a fault:E260dn DLP Hookup
Device
Function
Conn
Color
ATtiny13 MCU
Function
Operator Panel
3.3V
J5-5
BL
2
Pad no.’s = Pin no.’s
PB3
Cover Open
Switch Wires
5V
J7-1
YE
8
VCC
5V
J7-2
RD
GND
J7-3
BK
4
GND
Thermistor Substitute
5V
J12-1
BK
(J12-1>2.7k>J12-2)
(RD-VI-RD)
Fuser Temp
GND
J12-2
BK
New Paper In Sensor
(was narrow sensor)
0-5V
J14-1
RD
(Splice J14-1 wire to Sensor)
5V
J14-2
WT
7
Pad no.’s = Pin no.’s
SCK
GND
J14-3
BK
4
GND
Sensor
RD
(Splice Sensor wire to J14-1)
Sensor
BL
5
(4.99k to PAD 8 VCC)