Hi Marc & Mark,
I saw Marc's question marks on the same couple of wires I need some clarification on. I haven't seen any resolution yet, and wonder if these wires should be cut back to the connectors, left floating, or something else I am missing?
Below is my hookup chart. Is there anything that is incorrect, or needs adding?
I saw Marc's question marks on the same couple of wires I need some clarification on. I haven't seen any resolution yet, and wonder if these wires should be cut back to the connectors, left floating, or something else I am missing?
Below is my hookup chart. Is there anything that is incorrect, or needs adding?
MCU Board Hookup
Device
Function
Conn
Color
ATtiny13 MCU
Function
Operator Panel
3.3V
J5-5
BL
2
Pad no.’s = Pin no.’s
PB3
Cover Open
Switch Wires
5V
J7-1
YE
8
VCC
5V
J7-2
RD
GND
J7-3
BK
4
GND
New Paper In Sensor
(was narrow sensor)
0-5V
J14-1
RD
(Splice Sensor wire to J14 wire)
5V
J14-2
BL
5
4.99k to PAD 8 VCC