On 14. 12. 2014 06:09, Camillus camillus_blockx@...
[Homebrew_PCBs] wrote:
understand correctly the 8 cogs are interleaved by hub. The cog operates
at 20mips (like AVR) but hub rotate by half of that frequency. So more
or less the pixel generation should be done by one cog. other cog may be
used as refresh generator and data upload routine. I think that is not
best suited for that application.. maybe some of ARM chips is better?
Slavko.
[Homebrew_PCBs] wrote:
>I didn't work with propeller at all. But now I do quick check. And if I
>
> I was thinking that the propeller would be a good device for this
> project, it hass 10 cogs ( independent cores you may say ) and one
> master that controls the IO I think. I'm just stating what I remember
> from reading. The only drawback is the language,, not a common ....
>
> cb
>>
understand correctly the 8 cogs are interleaved by hub. The cog operates
at 20mips (like AVR) but hub rotate by half of that frequency. So more
or less the pixel generation should be done by one cog. other cog may be
used as refresh generator and data upload routine. I think that is not
best suited for that application.. maybe some of ARM chips is better?
Slavko.