Homebrew PCBs

On 16/05/14 07:47, Peter Johansson rockets4kids@... 
[Homebrew_PCBs] wrote:
> At the moment I have neither laminator nor UV source

I use a clothes iron to adhere dry film on boards smaller than the iron, 
on a very cool setting, works well, clean and dry board (and slightly 
warm if it if it's cold), remove protective layer from film, smooth on 
with fingers avoiding bubbles, cover with paper, put clothes iron 50 to 
75 degrees C on top, too hot and it will blister, wait about 30 seconds, 
then iron and press like your shirt for another 30s or so, paying 
special attention to edges.

Unless you live on Antarctica at the moment you have a UV source for a 
few hours a day at least :-)