Hi Jack,
I had good luck with purple cows laminator sold at Costco. However it takes several passes to get food results and I find it doesn't apply a lot of pressure after it gets heated up and used many times
I ordered an apache 13-something for 61 USD on eBay. People praise it fir PCB work, I got it last night and still didn't try it. Bit its built like a tank!
I had good luck with purple cows laminator sold at Costco. However it takes several passes to get food results and I find it doesn't apply a lot of pressure after it gets heated up and used many times
I ordered an apache 13-something for 61 USD on eBay. People praise it fir PCB work, I got it last night and still didn't try it. Bit its built like a tank!
From: Jack Schmidling
Sent: 10/4/2013 8:10 AM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Laminator
Sent: 10/4/2013 8:10 AM
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Laminator
Is there a preferred laminator for PCB making?
I have been at this for a few weeks and have tried many of the suggested
media and a few of my own. So far the best results have been with
magazine paper after I figured out what people meant by the term.
Hadn't a clue where one could purchase it.
PnP was a big disappointment and about the worst results.
PO label backing was the second best.
I suspect most of the problems are with uniform heat and pressure so the
laminator seems like a good idea.
As a point of interest, Yahoo seems to have really barfed up the Groups
lately and their stock has crashed in my humble opinion.
Thanks
Jack K9ACT
Astronomy, Beer, Cheese, Fiber, Gems,
Nature, Radio, Sheep, Sausage, Silver
http://schmidling.com