I've just bought a fellowes Venus 125 laminator, I've tried to use it without modding it but I think the temperature does not get over 130 C (265 F) so it does not work for TT out of the box, it can be fed with 1/16" boards easily, so I'll try to fix that in the next days, I'll comment my results later.
best regards
best regards
---In Homebrew_PCBs@yahoogroups.com, <homebrew_pcbs@yahoogroups.com> wrote:Is there a preferred laminator for PCB making?
I have been at this for a few weeks and have tried many of the suggested
media and a few of my own. So far the best results have been with
magazine paper after I figured out what people meant by the term.
Hadn't a clue where one could purchase it.
PnP was a big disappointment and about the worst results.
PO label backing was the second best.
I suspect most of the problems are with uniform heat and pressure so the
laminator seems like a good idea.
As a point of interest, Yahoo seems to have really barfed up the Groups
lately and their stock has crashed in my humble opinion.
Thanks
Jack K9ACT
Astronomy, Beer, Cheese, Fiber, Gems,
Nature, Radio, Sheep, Sausage, Silver
http://schmidling.com