As a follow up to this thread ...
I ordered the Jameco Drill Stand Works with Mini Drill (Part 26702) ...
Note
that I did not order the Miniature Drill 12000 RPM associated with it ...
because
I have a Dremel 4000 and was hoping to use that.
Regretfully the stand is not capable of supporting the Dremel 4000 securely. The Dremel 4000 is just too big and heavy.
I
am not sure if I will bother to get the "correct" motor. While I will admit that
for $28 plus shipping the stand is reasonably solid I feel the term "will not be
solid enough even with the smaller motor" applies.
---In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:
It appears to be the same as a "PZ541 Vertical Drill Stand".
I
do not have either one. Just wanted to pass along an additional set of 'tokens'
to Google for information.
--- In homebrew_pcbs@yahoogroups.com, <v321uk@...> wrote:
Intended use occasional PCB making.
Is there much 'run out' ?
Would you recommend it ?
I tried searching the group but cant see a text search only a message number search.
Thanks, John G3UGY