Homebrew PCBs

Why not use PVC?  It comes in all shapes and sizes (pvc pipe, sheet, solid
rods, etc...), and it can be connected in various ways (glued, welded, and
screwed using compatible material.  PVC screws can be found and used).  

Marty

-----Original Message-----
From: Stefan Trethan [mailto:stefan_trethan@...] 
Sent: Friday, November 21, 2003 10:29 AM
To: homebrew_pcbs@yahoogroups.com
Subject: [Homebrew_PCBs] PCB Holder construction and materials

Well, if stainless is no good in HCl,
which Materials would be good for constructing
a PCB holder for a vertical etch tank?


I think carbon reinforced tubes are very strong. (from rc model supply)
Does the HCl attack the carbon fibers? I think it should not be
a problem with epoxy resin (as pcbs are also this material).


How to construct a holder?
It should allow for etching on both sides and the full surface (no clamps 
or such stuff)


Any hints appreciated.

thanks

Stefan


Be sure to visit the group home and check for new Bookmarks and files:
http://groups.yahoo.com/group/Homebrew_PCBs

To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/