Recently I remember an article about using broken PCB carbide drilling bits
to make V tipped router bits. Basically grind the desired angle and then
grind off half the bit. There was a careful procedure to allow accurate and
good performance.
I have googled, hunted in the email lists, and my own computer without
success.
Any suggestions where I can find it?
[Non-text portions of this message have been removed]
to make V tipped router bits. Basically grind the desired angle and then
grind off half the bit. There was a careful procedure to allow accurate and
good performance.
I have googled, hunted in the email lists, and my own computer without
success.
Any suggestions where I can find it?
[Non-text portions of this message have been removed]