Homebrew PCBs

Its not viable becasuse etchant does not recirculate, you just pump it out of the vessel and to the board but if you try to put it back in, it will loose presure and stops spraying. 
To put it back in without pressure loss, it will need a pump capable of more pressure thats in the chamber, so the whole thing becames ilogicall.

Another way is to have LOTS of etchant and a very powerfull air pump to compensate for the volume, Raising cost to an unpractically level

However this is the kind of ideas that migth contribute to something in the future so I dont consider it a waste of time to give it a thougth or two.


--- In Homebrew_PCBs@yahoogroups.com, "Duane C. Johnson" <redrok@...> wrote:
>
> rolynd33 wrote:
> 
>  > What speaks against using a Bernoulli type sprayer for spray etching ?
>  > I did a search here but Bernoulli did not yield any viable results.
> 
> Try this:
> http://en.wikipedia.org/wiki/Atomizer_nozzle
> 
> Duane
> 
> -- 
>      Home of the $35 Solar Tracker      Receiver
>     http://www.redrok.com/led3xassm.htm      [*]
>    Powered by             \  \     \        //|
>   Thermonuclear   Solar Energy from the Sun / |
> Energy (the SUN)           \  \     \  /  /  |
> Red Rock Energy             \  \     /   /   |
> Duane C. Johnson   Designer  \  \  /  \ /    |
> 1825 Florence St  Heliostat,Control,& Mounts |
> White Bear Lake, Minnesota    === \   / \    |
> USA      55110-3364                ===   \   |
> (651)426-4766        use Courier New Font \  |
> redrok@...     (my email: address)  \ |
> http://www.redrok.com  (Web site)          ===
>