Homebrew PCBs

Is that this - http://www.bnkz.com/GBC/Laminator004.jpg

In there is one of these - http://www.daewood.com.hk/en/productdetail.asp?id=126&sortid=237&pid=

--- In Homebrew_PCBs@yahoogroups.com, "RDHeiliger" <rdheiliger@...> wrote:
>
> Insulating the snap switch (temperature switch) from the aluminum heater bars will raise the temperature. On mine the snap switch is held on by a screw, put a piece of bare circuit board or cardboard on each side of the tab on the switch. Experiment with thickness till you get good results.
> 
> RD
> 
> [Non-text portions of this message have been removed]
>