Homebrew PCBs

I assume you have the laminator modified to run at the correct temperature?

--- In Homebrew_PCBs@yahoogroups.com, "dubob4432" <dubob4432@...> wrote:
>
> tried it tonight and i get much better results w/ glossy magazine pages...weird.  using canon mf4150 and this laminator - http://www.amazon.com/gp/product/B001JXJ5HQ/ref=oh_details_o00_s00_i00
>  went through laminator 10x or so.
> maybe i did not let it release long enough in the water?  used the same type of vinyl as the dangerous prototypes used.
> 
> bob
> 
> --- In Homebrew_PCBs@yahoogroups.com, "dubob4432" <dubob4432@> wrote:
> >
> > anybody want to sell a foot or 2 by 8"+ of vinyl cheap?  would like to try this out but since i don't have a vinyl cutter, don't have any vinyl nor use for it if i can't get the desired results.
> > 
> > thanks in advance,
> > bob in AZ
> > 
> > --- In Homebrew_PCBs@yahoogroups.com, "brucethehoon" <amorrow@> wrote:
> > >
> > > I read this the other day:
> > > 
> > > http://dangerousprototypes.com/2012/09/29/pcb-manufacture-using-oracal-vinyl-film-laser-printer/
> > > 
> > > My results were SIGNIFICANTLY better than with the Pulsar paper, and I am getting results identical to my best photo transfers.   I am Andrew in the comments.
> > > 
> > > I link, in the comments, to the specific vinyl I used, but if there is interest in this group, I will re-try the same experiments with vinyl purchased from Amazon that features Prime shipping.  I have lots of vinyl laying about, and can likely find some.
> > >
> >
>