Homebrew PCBs

Thanks to all with suggestions.

I was thinking along the same lines. I did the obvious and checked it
out on their Support site. It sounds like it is a software mish-mash and
they have a procedure to get things going again. Sorry about the false
alarm! I like the little printer a lot but I am guilty (like most users)
of not reading the documentation before I have a problem!



--- In Homebrew_PCBs@yahoogroups.com, Chuck Bowling
<aardvarkstudio.chuckb@...> wrote:
>
> I'm not an expert but I'd suggest that you try cleaning it out. Get
some
> compressed air and try to get as much dust out of it as you can. The
> problem may be as simple as a dusty paper sensor.
>
>
> [Non-text portions of this message have been removed]
>