Homebrew PCBs

I use the Proxxon FBS rotary tool (You can also get the IB/E which is even better) in the MB 140/S Stand, after watching this: http://www.youtube.com/watch?v=1JyTf1tJXXo

Tool goes to 20,000 RPM so I think it's better for PCBs than the TBM drill press.

Also, with a router bit I can cut my PCB stock with it too.

Broken only one bit so far, because I accidentally moved the board while drilling.


--- In Homebrew_PCBs@yahoogroups.com, "Howard" <howard_g7lqy@...> wrote:
>
> Hi All
> Am having some probs with my drill\stand setup.
> 
> The stand is the type with a single slide piller,
> it is meant for a 240v work drill (i use a dremel drill )
> sometimes the stand will move from side to side and 
> snap the drill bit !!.
> 
> Can anyone suggest a good drill\stand combination, that
> will not give me these problems ?
> 
> I think that some of you use Proxxon products 
> any pros\cons ?
> 
> Look forward for any comments
> 
> Howard
>